Velleman-projects K8047 Assembly instructions Manual do Utilizador

Total solder points: 159 Difficulty level: beginner 1o 2 o 3 o 4 þ 5 o advanced 4 channel recorder / logger ILLUSTRATED ASSEMBLY MANUAL

10 13. Final assembly Final assembly You can close the housing and affix the front sticker after the final test.

11 Test 14. Connection Signal 4 + USB CABLE - A MALE TO B MALE INSTRUMENTSPCS10 / K8047USB INPUT* See manual for safety and operating instructions.

12 PCB & DIAGRAM

13 15. PCB layout. PCB

14 16. Schematic diagram. Schematic diagram

15 Notes :

16 Modifications and typographical errors reserved © Velleman Components nv. H8047IP - 2003 - ED1

2 VELLEMAN Components NV Legen Heirweg 33 9890 Gavere Belgium Europe www.velleman.be www.velleman-kit.com

3 1. Assembly (Skipping this can lead to troubles ! ) Ok, so we have your attention. These hints will help you to make this project success-ful. Re

4 1.3 Soldering Hints : Mount the component against the PCB surface and carefully solder the leads Make sure the solder joints are cone-shaped

I P E SF S DK N D GB F NL C O D E CODICE COLORE CODIGO DE CORES CODIGO DE COL-ORES VÄRI KOODI FÄRG SCHEMA FARVE-KODE FARGE-KODE FARB KODE

6 q J 1. Jumper q C1 : 220nF (224, 0.22) q C2 : 33pF (33) q C3 : 33pF (33) q C4 : 100nF (104, 0.1, u1) q C6 : 100nF (104, 0.1, u1) q C

7 Construction q LD1 : 3mm ‘Red’ => Recording q LD2 : 3mm ‘Green’ => Power ON q J5 : USB B90 8. USB connector 10. LED’s. Watch the p

8 G DO NOT CLOSE THE HOUSING YET & G DO NOT ATTACH THE FRONT STICKER YET A. Installation : • Install the software. If the necessary softwar

9 B. Test : • Hook-up a USB cable between a free port of your computer and the K8047 (see page 8.) • Connect a 9V battery to one of the signal in